Laboratory

BASIC ELECTRICAL LAB

Objectives: Major equipment 
1) Induction Motor 
(2.2KW, 3H.P, 415V, 50 Hz, 1425 rpm, 5A) 
2) DC Shunt Motor 
(220V, .5H.P, 2.9A , 1500 rpm)

CIRCUIT THEORY & NETWORK LAB

Objectives:

Major equipment 
1) MATLAB SOFTWARE 
2) MULTISIM SOFTWARE


CONTROL SYSTEM LAB

Objectives: Major equipment 
1) AC Position Control Setup with motor 
2) PID Controller 
3) DC Position Servo Mechanism Trainer

ELECTRICAL DRIVES LAB

Objectives: Major equipment: 
1) PC/PLC based AC/DC Motor Drive 
(PLC trainer for AC/DC drive, motor control operation based on SIMATIC S7-300, 230 v,1 phase , D.C motor- .5 H.P, 1500 rpm, 220v,AC motor.37 KW,1.05 Amp, 1380rpm.) 
2) Thyristor Control DC drive System 
( Digital controlled Industrial DC drive 0 .5 H.P, 110/220V dc,1500rpm)

MACHINE LAB-1

Objrctives: Major equipment 
1) D.C Power Supply 
(0-250 volt, 20A ) 
2) DC Shunt Motor 
(220V, .2KW, 9A , 1500 rpm) 
3)DC Series Motor 
(220V, .2H.P, 7.5A , 1500 rpm)

MACHINE LAB - 2

Objectives: Major equipments 
1. Experiment Setup for speed control of 3 phase squirrel cage induction motor. 
(3 phase, 1 hp, 1425 rpm, 415 volt, 2.1 A induction motor – 1; Ammeter: 0 – 5A – 1 no., Voltmeter; 0 – 500v – 1No., 3 phase variac (type – 2p-3p,1.6kVA 2A per line; input – 415v output 470v – 1no.; frequency controller – 1no., rotary switch – 1no., Contactor MCB 3 pole, 10 A, 440v – 1 No.)) 
2.Rectifier Unit 
(Input 3 phase Ac , Output – 220V(Dc), 50A)

ELECTRICAL MEASUREMENT LAB

Objectives: Major equipment 
1)Experimental Setup for Measurement of HF & VHF 
(This Setup Consist Of 250 MHZ, RF source with AM& FM , 150 MHz, counter & F.M , TX+ RX kit For Exp Like broad cast Antenna ) 
2) Experimental Setup for Wave Modulated & Spectrum Analysis 
(Consist of mixed Signal Generator , DMM, specially designed Q-meter System to find out all mixed frequency resonance indication on meter CRO & PC interface spectrum analyzer software to observe.)

POWER ELECTRONICS LAB

Objectives:

Major equipment 
1) APLAB 100 MHZ 
(2 Chanel digital storage oscilloscope with colour LCD display model-36100 DC) 
2) PSIM Software( 5 User)


POWER SYSTEM LAB

Objectives: Major equipment 
1) Setup For Test on C.T. & P.T (C.T. Ratio 100/5A, P.T. Ratio 1100/110v) 
2) Setup For Test on On Load & Off Load Time Delay Relay 
3) Setup For Test on Over Current Relay 
4) Setup For Test on Earth Fault Relay 
5) Setup For Test on Dielectric constant, Tandelta, Resistivity of transformer oil.

Our Recruiters